1. Make an electrical circuit.

You will need: 4.5v battery
Bulb and bulb holder
4 paper clips
Covered copper wire

Scrape the covering off the ends of a 30cm length of wire. Twist one end round a paper clip. Do the same with another 30 cm length of wire and another clip.
Fasten the clips to the terminals of the battery. Press the free ends of the wire to the bulb.

See what happens.

You have made a simple electric circuit.

Now screw the free ends of the wires to the terminals on the bulb holder and screw in the bulb.

Cut through one of the wires.

See what happens.

Scrape the covering off the ends of the wire you have just cut.

Twist each of these round a paper clip and press the two clips together.

See what happens.

What happens when you release your clips?

See if you can write about what happens and why.

You will need: 4.5v battery
Bulb and bulb holder
4 paper clips
Covered copper wire

First make an electric circuit similar to the one you have just made.

Leave a small gap between the two paper clips which make up the switch.

Place an iron nail across the gap so that it touches both of the clips.
See what happens.

Does the nail conduct electricity?

Test other materials to see if they are conductors or non-conductors of electricity e.g. pin, pencil, hair clip, scissors, straw, silver paper, coin, rubber band, various metals, paper clip.

Now it might help to write about and draw diagrams about what you did and what you found out and to make a table of conductors and non-conductors.